Electrolux EWG 14750 W - Manual (Page 15)

use electrolux 15
to the new programme position. Start
the new programme by pressing
button
8 again. The washing water in
the tub will not be emptied out.
Interrupting a programme
Press the button 8 to interrupt a
programme which is running, the
corresponding light starts to flash. Press
this button again to restart the
programme.
Cancelling a programme
Turn the selector dial to O to cancel a
programme which is running. You can
now select a new programme.
Opening the door after the
programme has started
First set the machine to PAUSE by
pressing the button
8.
If the icon disappears on the display,
the door can be opened.
If the icon does not go off, this
means that the machine is already
heating, that the water level is high.
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O. After
about a few minutes the door can be
opened (pay attention to the water
level and temperature!).
After closing the door, it is necessary to
select the programme and options
again and press button
8 .
At the end of the programme
The machine stops automatically. Some
acoustic signals sound for a few
minutes.
7.10
7.10
If a programme with an option that
ends with water still in the tub has
been selected,
the light of button 8 goes
off, three blinking « 0.00 » will appear on
the display .
The icon is still visualized and the
door remains locked to indicate that the
water must be emptied out before
opening the door.
To empty out the water:
● turn the programme selector dial to O
● select the Drain, Spin [and/or Delicate
Spin, when available] programme
● reduce the spin speed if needed, by
means of the relevant button
● press button 8
● at the end of the programm e, the
display shows three 0.00 flashing. The
icon disappears and the door
can be opened.
At the end of the cycle, turn the
programme selector dial to O to switch
the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out
another wash, close the water tap.
Leave the door open to prevent the
formation of mildew and unpleasant
smells.
Important!
If your laundry is not removed within 10
minutes after the programme is
finished, the backlight of the display
switches off and the energy saving
system will be enabled. Only the button
8 pilot light is blinking to indicate that
the appliance has to be switched off.
By pressing any button the appliance
will come out from the energy saving
status and you could set another
washing programme or switch off the
appliance.
7.10
7.10
132964640.qxd 19/07/2008 12.00 Page 15