Electrolux EWP 86100 W - Manual (Page 25)

The light of button 6 flashes and the light 7.1 illuminates: Problem with the water
supply
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked
• Clean the water inlet filters (read "Cleaning the water inlet fil-
ters" for more details).
The light of button 6 flashes and the light 7.2 illuminates: Problem with the water
drainage
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged
• If the appliance stops working without discharging the water ,
first carry out an emergency drain:
– Turn the programme selector dial to ;
– Unplug the appliance;
– Close the water tap;
– If necessary, wait until the water has cooled down;
– Unscrew the drain hose from the rear support (see "Frost
precaution") and unhook it from the sink or spigot;
– Let it run along the floor;
– Place a bowl on the floor and place the end of the draining
hose into the bowl. The water should drain by gravity into
the bowl. When the bowl is full, empty it. Repeat the proce-
dure until water stops flowing out ;
– Screw the draining hose to the rear support and reposition
it;
– Open the door and remove the laundry;
– Carry out the drain filter cleaning as described in "Cleaning
the drain filter";
– At the end of cleaning action, close the door and insert the
mains plug again;
– Run a drain programme to check if the appliance works
now.
The light of button 6 flashes and the light 7.3 illuminates: Door open
The door has not been closed or is not closed properly.
• Close firmly the door.
The appliance does not start or stops dur-
ing operation without any visible alarm. Before contacting your local Service Cen-
tre, please carry out the checks listed be-
low.
electrolux 25