Ericsson A1228c - Manual (Page 11)

Not for Commercial Use - Ericsson Inc.
Getting Started 5
!Ã Lift the battery up and out of the battery cavity.
Charging Your Battery
Your Charger
Your phone was packaged with either a
rapid or travel charger. It is important that
you fully charge your battery before you
use your phone. Both chargers supply
power to charge your battery while the bat-
tery is attached to your phone. If your
phone is On, it can receive calls while using
either charger.
Note! NEVER attach the charger to a phone that
does not have a battery installed.
à If you have a rapid charger, plug the
charger into a standard wall electrical
outlet. If you have a travel charger, connect the appropriate AC
power cord and phone charging cord to the travel charger.
!Ã Hold the phone with the display and keypad facing up.
"Ã Hold the small plug on the charger cord so the lightning bolt sym-
bol ( ) is up.
#Ã Align the small plug on the charger cord with the connector on
the bottom of your phone. The connector on the phone is above
the lightning bolt symbol.
$Ã Press the plug into the connector until the plug “snaps” into place.
The icon, which continuously fills and empties, is alternated
with the icon when the phone is powered on and is charg-
ing.
Note! Do not twist while inserting or removing the small plug on the
charger cord!
%Ã Continue charging the phone until the battery is fully charged.
When your phone is fully charged, the plug icon will remain sta-
ble.
&Ã To disconnect the charger, lift the plug connected to the phone
upwards and pull it out.
Charge-Only Mode
If your phone is off, attaching the charger will cause the phone to
activate in charge-only mode. When this mode is activated, an ani-
mated icon appears in the display. Your phone is now fast (rapid)
rapid
travel