Polaris 2013 WideTrak LX - Manual (Page 93)

89
MAINTENANCE
Track
Moving parts can cut and crush body parts. When performing the checks and
adjustments recommended on the following pages, stay clear of all moving
parts. Never perform track measurement or adjustments with the engine
running.
Track Tension
Track adjustment is critical for proper handling. Always maintain
correct tension and alignment. Tension adjustments should be made
only after the track is warmed up and limber.
WARNING! Improper track tension can cause serious damage to the
snowmobile, which can result in loss of vehicle control and serious injury or
death. Always maintain the track tension as specified.
1. Turn the engine off.
2. Lift the rear of the snowmobile and safely support it off the ground.
3. Place the recommended weight or downward pressure on the track
at the location specified (see chart and illustration).
4. Measure at the point where the weight is hanging.
5. Check for specified slack between the wear surface of the track clip
and the plastic rail slide.
Weight Measurement
Location
Measurement
10 lbs. (4.54 kg) 16 inches (40 cm) ahead of
forward idler wheel shaft bolt
3/4-1 inch (2-2.5 cm)
WARNING