Polaris 2016 600 Indy - Manual (Page 72)

70
THE PERFECT FIT
Handlebar Adjustments
When adjusting handlebar position or angle, be sure the handlebar,
brake lever and throttle lever operate smoothly and do not hit the gas
tank, windshield or any other part of the machine when turned fully to
the left or right. If necessary, adjust the left and right hand controls. See
page 69.
Handlebar Position
1. Loosen the upper handlebar
clamp screws.
2. Adjust the handlebar forward or
rearward to the desired
position.
3. Tighten the screws to
specification. Maintain an
equal gap between the clamp
and riser while tightening. Do
not over-torque.
Torque: 16 ft-lbs (21.6 Nm)
Handlebar Angle
1. Loosen the lower riser clamp
screws.
2. Adjust the riser to the desired
position.
3. Tighten the screws to
specification. Maintain an
equal gap between the clamp
and riser while tightening. Do
not over-torque.
Torque: 16 ft-lbs (21.6 Nm)
Handlebar
Clamp Screws
Riser Clamp
Screws