Mp4010, Plc-program from ram or from eprom entry: 0 or 1, 0 = eprom-operation 1 = ram-operation – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 489: Reset, 6 eprom creation
2.6 EPROM creation
Machine parameter MP4010 selects whether the PLC program is run from the RAM area of the
control or the EPROM area.
During the creation and test of the PLC program the control should operate from the RAM area.
HEIDENHAIN recommends that an EPROM is created for the PLC program before delivering the
machine to the customer (see also chapter "Introduction").
MP4010
PLC program from RAM or from EPROM
Entry:
0 = EPROM operation
1 = RAM operation
A PC and the MEGA-PROMMER-Software (Version 2.12.or later) are necessary for programming
the PLC EPROMS.
The PLC files from the RAM area in the control can be transferred to the PC via the data interface
(see chapter "Data interface").The output is initiated from the control with the soft key "BINARY
OUTPUT" (see section "PLC functions").
The PLC files are then transferred to the PC in the Motorola EXORMAX S3 format. With the MEGA-
PROMMER these data can be read in the MOX format and the EPROM programmed.
Please contact the HEIDENHAIN customer service if you have further questions.