HEIDENHAIN ND 2100G Installation - Manual (Page 14)

Installation Instructions
en
ND 2100G GAGE-CHEK
16
3 Mounting
The following steps are only to be performed by
qualified personnel!
For more information: see "Personnel
qualification", page 14.
Unpacking
Open the top lid of the box.
Remove the packaging materials.
Unpack the contents.
Check the delivery for completeness.
Check the delivery for damage.
If any components were damaged in transit,
keep the packaging materials for inspection and
contact your HEIDENHAIN distributor or OEM.
This applies also if you need replacement parts.
In case of damage in transit
Have the shipping agent confirm the damage.
Keep the packaging materials for inspection.
Notify the sender of the damage.
If necessary, contact your distributor for mediation.
Contact your HEIDENHAIN distributor or OEM for
replacement parts.
Items supplied
The following items are included in the shipment:
Unit with pre-installed mounting adapter
or
Unit with separate mounting stand for assembly on site
Protective cover for the unit
Power cord
Connector for relay contacts
Installation Instructions
Addendum (optional, for more information see "Notes on
reading the documentation", page 13)
Accessories
The following items are optionally available and can be
ordered from HEIDENHAIN as additional accessories:
Optional accessories ID number
Mounting adapter 682419-01
Mounting stand 382892-02
Foot switch 681041-01
Remote keypad 681043-01
QUADRA-CHEK Wedge
communication software
709141-01
Protective cover 681051-03
3.2 Assembly
If the unit is supplied with pre-installed mounting
adapter, no assembly is required.
If the unit is supplied with separate mounting stand, the
stand needs to be attached. For more information see
"Attaching the mounting stand", page 16
Attaching the mounting stand
See "C" on the front fold-out page.
Mounting the unit with mounting stand on a benchtop
or machine (optional)
Using the mounting holes provided on the underside of
the mounting stand, you can firmly screw the unit to a
benchtop.
Horizontal tilting of the unit in the tilt guides is still possible
after screw-mounting.
If the unit has a pre-installed mounting adapter,
you need to remove the mounting adapter first
and then attach the mounting stand. For more
information see "Attaching the mounting stand",
page 16. The mounting stand is available as
an optional accessory (ID 382892-02).
The mounting adapter is removed in the reverse
order in which the mounting stand is attached.
Dimensions for screw mounting
See "F" in the Appendix.
When mounting the unit on a benchtop or
machine, choose a surface that is flat and stable
and provides sufficient space for installation and
operation.
The surface has to be accessible from the rear to
allow screw mounting of the unit.
Mounting the unit with mounting stand on a
benchtop or machine
Drill four holes at the desired mounting location.
Align the mounting holes of the unit with the holes you
drilled.
To fasten the mounting stand to the mounting location,
insert and tighten the four M5 screws from the rear.
Mounting the unit with mounting adapter on a support
arm or benchtop
Using the mounting holes on the underside of the pre-
installed mounting adapter, you can screw the unit to a
support arm or benchtop.
Dimensions of mounting adapter
See "G" in the Appendix.