HEIDENHAIN NC 124 - Manual (Page 73)

6 Programming Workpiece Positions
TNC 124 73
Transferring positions: Teach-In mode
Teach-In programming offers the following two options:
• Enter nominal position, transfer nominal position to program,
move to position.
• Move to a position and transfer the actual value to a program
via soft key or through the actual-value-capture key on the
handwheel.
You can change transferred position values during Teach-In.
Preparation
➤ With Program number select the program you want transfer
positions to.
➤ Select the tool data from the tool table.
Feed rate F for Teach-In
Before starting the Teach-In process define the feed rate at which the
tool should move during Teach-In:
➤ Select the Teach-In function and enter a block with the desired
feed rate F first.
➤ Press the NC- I key.
Overview of functions
Function Soft key/Key
Go to the next block
Go to the previous block
Delete the current block