Programming the first part 1.3 – HEIDENHAIN TNC 320 (77185x-01) User Manual
Page 51
Programming the first part
1.3
1
TNC 320 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
51
Enter Retract tool: Press the orange axis key
Z in
order to get clear in the tool axis, and enter the
value for the position to be approached, e.g. 250.
Press the
ENT key
Radius comp.: RL/RR/no comp.? confirm with the
ENT key: Activate no radius compensation
Confirm
Feed rate F=? with the ENT key: Move at
rapid traverse (
FMAX)
MISCELLANEOUS FUNCTION M? Enter M2 to enter
end of program, then confirm with the
END key.
The TNC saves the entered positioning block
Further information on this topic
Complete example with NC blocks
movements and chamfers with Cartesian coordinates",
page 205
Creating a new program: see "Opening programs and entering",
page 87
Approaching/departing contours: see " Approaching and
departing a contour", page 188
Programming contours: see "Overview of path functions",
page 196
Programmable feed rates: see "Possible feed rate input",
page 92
Tool radius compensation: see "Tool radius compensation ",
page 177
Miscellaneous functions (M): see "M functions for program run