HEIDENHAIN TNC 410 ISO Programming - Manual (Page 7)

HEIDENHAIN TNC 410, TNC 426, TNC 430 III
Changed features of the NC software 280 476-xx
n The feed-rate unit for M136 was changed from µm/rev to mm/rev.
(see “Feed rate in millimeters per spindle revolution: M136 (not TNC
410)” on page 159)
n The size of the contour memory for SL cycles was doubled. (see “SL
Cycles Group II (not TNC 410)” on page 265)
n
M91 and M92 are now also possible with tilted working plane. (see
“Positioning in a tilted coordinate system” on page 306)
n Display of the NC program during the execution of pallet tables (see
“Program Run, Full Sequence and Program Run, Single Block” on
page 8) and (see “Screen layout for executing pallet tables” on page
95)
New/Changed Descriptions in this Manual
n
TNCremoNT (see “Data transfer between the TNC and
TNCremoNT” on page 398)
n Summary of input formats (see “Input format and unit of TNC
functions” on page 443)
n Mid-program startup of pallet tables (see “Mid-program startup
(block scan)” on page 380)
n
Exchanging the buffer battery (see “Exchanging the Buffer Battery”
on page 445)