HEIDENHAIN TNC 620 (340 56x-03) ISO programming - Manual (Page 214)

214 Programming: Q Parameters
8.7 A
d
ditional F
unctions
1017 CYCL incomplete
1018 Plane wrongly defined
1019 Wrong axis programmed
1020 Wrong rpm
1021 Radius comp. undefined
1022 Rounding-off undefined
1023 Rounding radius too large
1024 Program start undefined
1025 Excessive nesting
1026 Angle reference missing
1027 No fixed cycle defined
1028 Slot width too small
1029 Pocket too small
1030 Q202 not defined
1031 Q205 not defined
1032 Q218 must be greater than Q219
1033 CYCL 210 not permitted
1034 CYCL 211 not permitted
1035 Q220 too large
1036 Q222 must be greater than Q223
1037 Q244 must be greater than 0
1038 Q245 must not equal Q246
1039 Angle range must be < 360°
1040 Q223 must be greater than Q222
1041 Q214: 0 not permitted
Error number Text