HEIDENHAIN TNC 620 (81760x-02) - Manual (Page 310)

Programming: Q parameters
9.8 Additional functions
9
310
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 2/2015
Error number Text
1064 No measuring axis defined
1065 Tool breakage tolerance exceeded
1066 Enter Q247 unequal to 0
1067 Enter Q247 greater than 5
1068 Datum table?
1069 Enter Q351 unequal to 0
1070 Thread depth too large
1071 Missing calibration data
1072 Tolerance exceeded
1073 Block scan active
1074 ORIENTATION not permitted
1075 3-D ROT not permitted
1076 Activate 3-D ROT
1077 Enter depth as negative
1078 Q303 in meas. cycle undefined!
1079 Tool axis not allowed
1080 Calculated values incorrect
1081 Contradictory meas. points
1082 Incorrect clearance height
1083 Contradictory plunge type
1084 This fixed cycle not allowed
1085 Line is write-protected
1086 Oversize greater than depth
1087 No point angle defined
1088 Contradictory data
1089 Slot position 0 not allowed
1090 Enter an infeed not equal to 0
1091 Switchover of Q399 not allowed
1092 Tool not defined
1093 Tool number not allowed
1094 Tool name not allowed
1095 Software option not active
1096 Kinematics cannot be restored
1097 Function not permitted
1098 Contradictory workpc. blank dim.
1099 Measuring position not allowed
1100 Kinematic access not possible
1101 Meas. pos. not in traverse range
1102 Preset compensation not possible