HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 613)

Machine-specific user parameters 19.1
19
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
613
Parameter settings
DisplaySettings
Behavior with control start-up
Acknowledge "Power interrupted" message
TRUE: Control start-up is not continued until the message has been acknowledged
FALSE: "Power interrupted" message not displayed
DisplaySettings
Display mode for time display
Selection for display mode in the time display
Analog
Digital
Logo
Analog and Logo
Digital and Logo
Analog on Logo
Digital on Logo
DisplaySettings
Link row On/Off
Display setting for link row
OFF: Deactivate the information line in the operating mode line
ON: Activate the information line in the operating mode line
DisplaySettings
Settings for 3-D graphic simulation
Model type of 3-D graphic simulation
3-D (processor-intensive): Model display for complex machining with undercuts
2.5-D: Model display for 3-axis machining
No Model: Model display deactivated
Model quality of 3-D graphic simulation
very high: High resolution; Display of block end points possible
high: High resolution
medium: Medium resolution
low: Low resolution
DisplaySettings
Settings for position display
Position display with TOOL CALL DL
As Tool Length: The programmed oversize DL is considered as a tool length modification
for display of the workpiece-oriented position
As Workpiece Oversize: The programmed oversize DL is considered as a workpiece
oversize for display of the workpiece-oriented position