6 using an external speaker, 7 data cable installation, Using an external speaker – EFJohnson 001-9800-001 User Manual

Page 20: Data cable installation, Data cable installation (-001 cable shown) -7, Section 2.7

Advertising
background image

INSTALLATION

2-7

February 2001

Part No. 001-9800-001

Figure 2-6 Data Cable Installation (-001 Cable Shown)

Strain Relief

Accessory

J301

J701

Two User-Definable Wires

Pigtail Cable

Data Pigtail Cable

installed. Then install the mounting bracket using
the included self-tapping screws or other screws if
desired.

2. Install the control unit in the bracket using the

included knobs and vulcanized washers (the
washers are installed between the bracket and
control unit).

3. Install the included microphone hanger in a conve-

nient location using the included sheet metal screws
or other screws. For proper operation of functions
such as the monitor mode and scan, the hanger must
be connected to chassis ground. If required, ground
the hanger using the included ground wire.

2.6 USING AN EXTERNAL SPEAKER

Power output with the internal 8-ohm speaker in

the front panel or remote control unit is approximately
3 watts. For up to 5 watts of power, a 4.7-ohm external
speaker can be used. This speaker is plugged into the
external speaker jack on the back of the transceiver.
This is a standard 1/8”, two-conductor phone jack. The

internal speaker is automatically disabled when an
external speaker is used.

The impedance of the external speaker must not

be less than 4.0 ohms. Using a speaker with an imped-
ance less than 4.0 ohms could result in audio ampli-
fier U306 overheating and does not provide 5 watts of
power. Therefore, to allow for tolerances, a speaker
with a nominal impedance of 4.7 ohms is recom-
mended. The E.F. Johnson remote speaker listed in
Figure 2-1 or Table 1-3 meets this requirement. This
speaker has a 6-ft cable, and in some applications
(such as remote mounting) an extension cable may be
required to connect it to the transceiver.

2.7 DATA CABLE INSTALLATION

CAUTION

DO NOT apply power a transceiver that has one of the
data cables installed without first properly terminating
the wires of that cable. These wires carry differing
potentials and transceiver damage may result if they
inadvertently contact each other.

Advertising
This manual is related to the following products: