Emerson PD6870CH - Manual (Page 5)

Battery Operation
The battery compartment is located on the rear of the unit.
• Remove the battery compartment door by pressing down on the two arrow marks and sliding the door in
the direction of the arrows.
• Insert eight (8) ‘C’ size batteries into the battery compartment as shown below. Be sure to observe the
polarity markings which are engraved inside the battery compartment. If the batteries are inserted
incorrectly, the unit will not operate.
• Replace the battery compartment door.
NOTE: The AC power cord must be disconnected from the AC socket on the back of the unit in order for the
unit to operate on battery power.
4
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh
ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
+ + - -
+ + - -
+ + - -
+ + - -
PREPARATION FOR USE (CONTINUED)