Lanner RS12-38800 - Manual (Page 46)

RS12-38800
46
Configuration options: [Disabled] [Auto].
Block (Multi-sector Transfer): Enables or disables data multi-sector transfers.
When set to Auto, the data transfer from and to the device occurs multiple sectors
at a time if the device supports multi-sector transfer. When set to [Disabled], the
data transfer from and to the device occurs one sector at a time.
Configuration options: [Disabled] [Auto].
PIO Mode: Selects the PIO mode,
Configuration options: [Auto] [0] [1] [2] [3] [4].
DMA Mode: Selects the DMA mode.
Configuration options: [Auto] [DMA0][SWDMA1] [SWDMA2] [MWDMA0]
[MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4] [UDMA5].
SMART Monitoring: Sets the Smart Monitoring, Analysis, and Reporting
Technology. Configuration options: [Auto] [Disabled] [Enabled].
32Bit Data Transfer: Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled].
Hard Disk Write Protect: Write protection effective only if device is accessed
through BIOS.
Configuration options: [Disabled] [Enabled].
IDE Detect Time Out (Sec): Select the time out value for detecting ATA/ATAPI
device(s).
Configuration options:
[0] [5] [10] [15] [20] [25] [30] [35]
ATA (PI) 80Pin Cable Detection: Select the mechanism for detecting 80Pin ATA
(PI) cable.
Configuration options: [Host & Device] [Host] [Device]
Super IO Configuration: Press <Enter> to enter the sub-menu and the following
screen appears:
Serial Port1/2 Address:
These items specify the base I/O port addresses of the onboard Serial Port 1