Chapter 4, Introduction, Installing a compactflash card – Lanner LEC-6020 User Manual
Page 24: Connecting power
24
Introduction
Chapter 4
Embedded and Industrial Computing
Installing a CompactFlash Card
LEC-6020 provides one CompactFlash slot. Follow the
procedures bellow to install a CompactFlash card.
Unscrew the screws on the side to take out the cover.
1.
Align CompactFlash and the card slot with the arrow
2.
on the CompactFlash pointing toward the connector.
Insert the CompactFlash into the connector.
3.
Close the cover and fasten it with the screws to the
4.
slot.
Note: The device has an error proof design so that
the card will not be inserted if it is in the wrong
orientation. You should insert the CF card with the
arrow on the CompactFlash facing up and pointing
toward the connector.
1
2
Connecting Power
Connect the LEC-6020 to a 12~36 VDC power source. The
power source comes from the AC/DC Adapter through a
Phoenix contact. This power socket is specially designed
to guard against fault in power contact, i.e., the reverse of
the electrical polarity will not damage the system.
-DC in +
- +
- +
P-fail