Excalibur electronic H630BK - Manual (Page 4)

2. Lift the
RUBBER BACK
COVER
and locate your
RIP
CORD
.
3. Hold the unit parallel
to the ground and pull the
RIP CORD
. To achieve a par-
tial charge, pull the
RIP
CORD
approximately 80
times in one minute. Please
note, keep the unit parallel
and pull
RIP CORD
straight.
The charge will not be
effective, if the
RIP CORD
is
pulled at an angle greater
than 30º (see Diagram 1,
page 6).
Pull the
RIP CORD
at a
speed of approximately 80
times per minute. This will
provide 20-30 minutes of
flashlight light and one
minute of cell phone time.
The pulling force for the
RIP
CORD
must be constant and
of moderate speed.
It is recommended to
charge your Forever
Flashlight Rip Cord for
three to five minutes either
before the first time you use
it or after a long period of
non-use of your unit.
NOTES:
• Important. It is sug-
gested that pulling the
RIP
CORD
should not be allowed
to go past the red color of
the cord. This will damage
the unit and not allow for
maximum electricity.
• While pulling the
RIP
CORD
of the Forever
Flashlight Rip Cord, an
indicator light will be on.
This will signify that the
charging is in the process.
6
7
Charging the Forever
Flashlight Rip Cord
Your Forever Flashlight
Rip Cord includes two great
options to charge your unit.
For directions on each
option see right:
Charging your unit
using your built-in
rechargeable batteries.
It is charged by pulling
the
RIP CORD
on the unit.
Your
RIP CORD
is located in
the rear of the flashlight
under the
RUBBER BACK
COVER
. For best results, fol-
low these steps in charging:
1. Turn the unit off.
How to Use
Diagram 1
Important. It is suggested that pulling
the
RIP CORD should not be allowed to
go past the red color of the cord. This will
damage the unit and not allow for
maximum electricity.
6.6 LBS