Excalibur electronic H630BK - Manual (Page 5)

• If your unit is com-
pletely drained of energy,
you should pull the
RIP
CORD
again three to five
minutes. Keep in mind, that
if the Forever Flashlight
Rip Cord has not been uti-
lized for a long length of
time, it will cause the bat-
tery life to be shorter than
normal even after recharg-
ing.
In this case, recharge the
battery by pulling the
RIP
CORD
for three to five min-
utes. This will allow the
internal rechargeable bat-
tery to reactivate and charge
completely.
• While charging by
using the
RIP CORD
, remem-
ber to turn the unit off.
• If you utilize and pull
the
RIP CORD
slowly, the
batteries can not be charged
properly. The recommended
pull speed would be 80
pulls per minute.
Charging your unit
using an AC/DC
adaptor.
Simply turn off your unit
and use your
DC INPUT
JACK
located on the side of
your unit, connect an
AC/DC adaptor cord and
then plug into an electrical
outlet. Your built-in batter-
ies will be fully charged
within three hours. Do not
leave plugged into an outlet
for more than 24 hours.
This will damage your
internal rechargeable batter-
ies.
Using the flashlight
Your Forever Flashlight
Rip Cord includes an ultra
bright
5 LED S
light.
8 9
This energy saving light
uses minimal power con-
sumption. To use the flash-
light, first, set the
LIGHT
SWITCH
to either
LIGHT / OFF /
SIREN
/
BLINK
. The choice
between
LIGHT
,
OFF
,
SIREN
,
and
BLINK
, will adjust the
features of the flashlight.
The
LIGHT
switch will
allow a super bright 5
LEDS
light to brighten your path.
The
SIREN
switch will
allow a loud emergency
siren signal. At the same
time this will allow the
LED
light to
BLINK
. What a great
feature for when you are in
need of help.
To turn off the flashlight,
switch the
LIGHT SWITCH
to
OFF
.
Charging your
cell phone
Your Forever Flashlight
Rip Cord also has a great
additional feature –you can
charge your cell phone (or
other electrical items with
low voltage) anywhere you
are located. For best results,
follow these steps in charg-
ing your phone:
1. Pull your Forever
Flashlight Rip Cord for one
minute prior to plugging
your phone charge cord in.
2. Connect the phone
charge cable into the DC
OUTLET JACK
. This is locat-
ed on the side of the unit.
See page 4 for the location
of the
CELL PHONE CHARG -
ING OUTPUT
.