Empire Products COMFORT SYSTEMS EE-25-2 - Manual (Page 16)

Page 16 R-2688
. ...
.
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with
the National Electrical Code ANSI/NFPA No. 70, if an external
electrical source is utilized. This appliance is equipped with a
three-prong [grounding] plug for your protection against
shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug. For an ungrounded receptacle,
an adapter, which has two prongs and a wire for grounding, can be
purchased, plugged into the ungrounded receptacle and its wire
connected to the receptacle mounting screw. With this wire
completing the ground, the appliance cord plug can be plugged
into the adapter and be electrically grounded.
CAUTION: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
Oiling Blower Motor
The blower motor does not have oiling holes. Do not attempt to oil
the blower motor.
WARNING:
Unplugging of blower accessory will not stop the heater
from cycling. To turn off gas to the unvented heater: Push
in gas control knob slightly and turn clockwise to "OFF."
Do not force.
Index Part
No. Number Description
1 R-1468 Bushing
2 VF-153 Mounting Bracket
3 R-2695 Motor
4 R-2696 Fan Blade
5 R-2104 Fan Control
6 DV-806 Switch Box
7 DV-807 Switch Box Cover
8 R-2113 Spacer
9 R-896 Bushing
10 R-2091 Wire Assembly
11 VF-068 Cord Set
PARTS LIST
If any of the original wire as supplied with the appliance must be replaced,
it must be replaced with type 125
° C wire or its equivalent.
OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)