Empire Products COMFORT SYSTEMS EE-25-2 - Manual (Page 9)

Page 9 R-2688
Refer to Figure 7 for measurements in order to locate (3) mount-
ing holes on wall. Figure 7 is the front view of the heater.
On Solid Wall
1.
After locating mounting holes, attach (3) #10 x 1" (25mm)
screws provided into the wall. Do not completely tighten
screwheads to the wall, leave a 1/8" (3mm) gap between
screwheads and wall.
2. Mount heater onto the (3) screwheads and complete
tightening screwheads into the wall.
3. Connect the gas line.
On Sheet Rock Wall
1.
After locating mounting holes, drill (3) 5/16" (8mm)
diameter holes into the wall.
2. Insert (3) plastic expansion anchors provided into the
holes.
3. Tighten (3) #10 x 1" (25mm) screws provided into the
plastic expansion anchors. Do not completely tighten
screwheads to the plastic expansion anchors, leave a 1/8"
(3mm) gap between screwheads and plastic expansion
anchors. Refer to Figure 8.
4. Mount heater onto the (3) screwheads and complete
tightening the screwheads to the plastic expansion anchors.
5. Connect the gas line.
Figure 8
OPTIONAL FLOOR STAND INSTALLATION
Figure 7
Optional EES-25 Floor Stand Installation
1. Remove (4) screws located in bottom of heater.
2. Align clearance holes on floor stand and clearance holes
on spacers with screw holes on bottom of heater (See
Figure 9).
3. Attach floor stand to heater with (4) #10 x 1" screws
provided with floor stand.
4. Connect the gas line.
Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other
combustible material, other than wood flooring, the appliance
shall be installed on a metal or wood panel extending the full
width and depth of the appliance.
Attention: Optional EES-25 Floor Stand meets requirement.
The base referred to above does not mean the fire-proof base as
used on wood stoves. The protection is for rugs that are extremely
thick and light colored tile.
Figure 9
WALL MOUNT INSTALLATION