Extron electronic RSB 126 - Manual (Page 21)

SW USB Series • Operation
Operation, cont’d
3-10
SW USB Series Troubleshooting
If the SW USB detects a non-standard keyboard and/or mouse,
an error condition may occur in which the Exec Mode LED
blinks and the SW USB reboots in a repeating cycle. If this
happens, set the host emulation DIP switch(es) to off, and wait
for the switcher to reboot.
You will not be able to use host emulation with that keyboard or
mouse.
Peripheral emulation (SW4 USB Plus only)
In addition, the SW4 USB Plus emulates a mouse and keyboard
to the computer or other input device that is connected to
the selected input port. This emulation of peripheral devices
is constant, whether or not a keyboard or mouse is actually
connected to these ports, facilitating problem-free boot-up.
Keyboard and mouse emulation is always present on the inputs
of the switcher.
4
Chapter Four
SIS Configuration and Control
Host-to-Switcher Communications
Using the Command/Response Table
Updating the Firmware