Parkside PNTS 1300 - Manual (Page 7)

7
CY IE GB
Contents
Unpack the appliance and check that it is
complete:
The appliance is supplied with the motor head
fitted (see
A
No. 1). To remove the motor
head, open the securing clips (see A
No. 10).
A
1 Motor housing
2 Carrying handle
6 Schmutzbehälter
7 4 feet with castors and accessory
fittings
12 3-part vacuum tube
13 Vacuum hose with
15 Foam filter for wet vacuuming
16 Material filter for dry vacuuming
17 Paper filter bag for vacuuming fine dust
18 Floor nozzle with
20 Crevice nozzle
6 cross-head screws
Dispose of the packaging material properly.
Assembly
Pull out the mains plug.
This will prevent danger of injury from
electric shock.
B 1. Attach the carrying handle (2) firmly
using the cross-head screws supplied.
2. Attach the feet (7) and secure the feet
with the Philips head screws supplied.
3. Insert the filter:
- Foam filter for wet vacuuming (see
C
No. 15).
- Foam filter plus material filter (see
D
No. 16) for dry vacuuming
- Paper filter bag for fine dust
(see D
No. 17)
Never vacuum without a filter!
4. Place the motor housing (1) on top
of the dirt collector (6) and close it
with the clip (10).
5. Connect the vacuum hose (13) (Bayo-
net closure) and the accessories.
Switching on/off
Connect the mains plug.
Switching on the vacuum:
On / off switch (see
A
No. 3)
in position “I”
Switching off the vacuum:
On / off switch (see
A
No. 3)
in position “O”
C Wet vacuuming
In order to wet vacuum, attach the foam filter
(15) onto the filter tray. Only use a dry filter.
If the waste tank is full, a float closes
the suction opening, and the vacuum
operation is interrupted. Switch off the
machine and empty the waste tank.
If foam or liquid exits, switch off the
machine immediately.
D Dry vacuuming
In order to dry vacuum, put the material filter (16)
over the filter tray with the attached foam filter (17).
Fine dust vacuuming:
When vacuuming very fine dust, you
may find dirt accumulating more quickly
than usual. We therefore recommend ad-
ditional use of the paper filter bag.
Insert the fabric filter
1. Fit the fabric filter (16) over the filter bas-
ket with attached foam filter (15).
Insert the paper filter bag