Gb ie cy, Blowing, Cleaning/maintenance/ storage – Parkside PNTS 1300 User Manual

Page 8: Warranty

Advertising
background image

8

PNTS1300-061009op

GB

IE

CY

2. Fold down the side flaps on the paper fil-

ter bag (21) at the perforation.

3. Fit the paper filter bag (17) with the short flap

upwards over the internal suction pipe (22)

(see arrow

). The sealing ring (23) at

the filter bag opening must completely sur-

round the lip (24) on the suction pipe.

E

Blowing

To use the blower function, screw the suction

hose (13) (bayonet closure) to the connection

on the motor head (1).

Cleaning/Maintenance/

Storage

Pull out the mains plug.

This will prevent danger of injury from
electric shock.

Cleaning the appliance

Never hose the appliance down with

water. Never use aggressive clean-
ing agents or solvents. This could
damage the appliance.

• After use, empty the waste tank.

• Clean the waste tank with a damp cloth.

• Wash the foam filter with lukewarm water

and soap, and allow to dry.

• Beat out the material filter. If necessary,

wash with lukewarm water and soap and
allow to dry.

• Replace the paper filter bag when full (see

“replacement parts” for reordering)

Storage:

F

- For storage, wind the cable around

the cable holder (7) at the back of
the appliance.

- Insert the separated vacuum tubes

into the accessory holder on the ap-
pliance feet (11).

- The attachment ports (6) on the

motor part serve as nozzle storage

(see

A

No. 4) or on the feets.

• Store the appliance in a dry place and out

of reach of children.

• Always check the appliance before use for

any obvious faults such as a defective mains

cable, and have these repaired or replaced.

Warranty

This unit has a guarantee period of 36
months, or 12 months for units used on a
commercial basis or for replacement units ac-

cording to the statutory regulations. Damage
resulting from normal wear and tear, over-
loading or improper use is excluded from the
warranty. Certain parts such as the filters and

attachments are subject to normal wear and
tear and are excluded from the warranty.
Warranty claims can only be recognised if the di-

rections in the Operating Instructions on cleaning

and maintenance have been followed. Damage
resulting from material defects or manufactur-
ing errors will be rectified at no extra charge by
replacement or repair, on condition that the ap-
pliance has not been dismantled and is returned
to our Service Centre with proof of purchase and
guarantee (see addresses page 9).

You can have repairs which are not covered by

the warranty carried out by our Service Center

which will charge you for this. They will be
happy to draw up a cost estimate for you.
We can only carry out work on machines which
have adequate packaging and postage.
Warning:

In the case of a warranty claim or

a service, please deliver your machine to our
service address in a clean condition accom-
panied by a description of the problem.
Machines sent without prepaid postage
– as bulky goods, express, or by special
freight – will not be accepted.

If you have a justified guarantee claim, please

contact our service centre by telephone,
which will then advise you on how the claim

Advertising