Operation, Filling the blast medium container, Using the sandblasting gun (see figs. b, c) – Parkside PDSP 1000 A1 User Manual
Page 47
47
GB/MT
Operation
Q
Filling the blast medium container
J
Always use a suitable blast medium for your sand blasting work.
NOTE: We recommend using a silica-free blast medium
(e.g. ground blast furnace slag) with a grading of 0.2 mm – 0.8 mm.
j
Ensure that the blast medium is completely dry and not too coarse.
NOTE: The maximum particle size is 0.8 mm.
j
Turn the bayonet cap of the blast medium container
4
to open it.
j
Pull the blast medium container
4
off downwards.
j
Fill the blast medium container
4
with the desired amount of
blast medium.
j
Ensure that the maximum capacity of the container (1000 ml) is
not exceeded.
j
Screw the blast medium container
4
back on and lock it in place
by inserting and turning it on to the container lid (see Figs. A).
Q
Using the sandblasting gun
(see Figs. b, c)
j
Carefully prepare the workpiece before sand blasting it.
Clean it if necessary.
NOTE: Deposits of dust and grease can have a considerably
detrimental effect on the result.
j
Carefully mask or tape off everything that is not to be sand blasted.
j
Ensure that there is always a minimum distance of 20 cm between
the sandblasting gun
1
and the surface being sand blasted.
Switching on:
j
Press the trigger
2
to start operating the sandblasting gun
1
.
64574_par_Druckluft-Sandstrahlpistole_content_LB5.indd 47
17.03.11 13:49