Parkside PDSP 1000 A1 - Manual (Page 12)

12 GB
Operation / Cleaning / Service
Switching off:
j Release the trigger 2 to stop operating the sandblasting gun 1 .
j After you finish work, disconnect the device from the compressed
air source.
NOTE: First disconnect the hose from the compressed
air source and only then disconnect the compressed
air supply hose from the device. This will ensure that the
compressed air supply hose does not wave around in an uncon-
trolled manner.
Q
Cleaning
J DANgER OF INJURY! Always disconnect
the device from the compressed air source before you clean or
maintain it.
j Clean the sandblasting gun 1 and blast medium container 4
after you finish working. Blow out the sandblasting gun 1 and
the blast medium container 4 with compressed air.
j Store the sandblasting gun 1 in a dry, enclosed room.
Q
Service
J Have your sandblasting gun repaired
only by qualified specialist personnel using original
manufacturer parts only. This will ensure that your sandblast-
ing gun remains safe to use.
64574_par_Druckluft-Sandstrahlpistole_content_LB4.indd 12 17.03.11 13:39