Handling and operation, Switching the appliance on and off, Optimal working procedures – Parkside PAS 500 C2 User Manual
Page 60
57
PAS 500 C2
GB
MT
NOTICE
►
On the assembly or release of the suction hose,
11
grasp the black plastic
end piece and not the suction hose itself
11
. The suction hose
11
could be
damaged by twisting or bending.
♦
Insert the suction pipe
12
into the rigid end piece of the suction hose
11
.
Handling and operation
In this chapter you receive important information about the handling and opera-
tion of the appliance.
Switching the appliance on and off
♦
Insert the power plug into a mains wall socket.
♦
To switch the appliance on, place the On/Off switch
6
at the position "ON".
♦
To switch the appliance off , place the On/Off switch
6
at the position "OFF".
Optimal working procedures
WARNING
►
The vacuuming up of glowing ash and combustible, explosive or health
hazardous materials is strictly prohibited.
►
Only vacuum cold ashes. Cold ash is ash, which has cooled for suffi ciently
long and contains no embers. This can be determined by combing over the
ash with a metal tool before the appliance is used. From cold ash there is
no perceptible heat radiation.
♦
Place the appliance on a level and heat-resistant surface.
♦
Always use the suction pipe
12
for vacuuming. Hold the suction pipe
12
at
a distance of approximately 1 cm above the ashes.
♦
Vacuum only ashes cooled to below 40°C.
♦
When vacuuming, constantly check the metal container
10
and the vacuum
hose
11
for warming.
♦
In the event of the appliance heating up, switch it off and disconnect the
plug from the mains power socket. Let the appliance cool down outdoors
under supervision.
♦
During work pauses you can insert the suction pipe
12
into the accessory
storage
2
on the container lid
5
.
♦
When transporting the appliance always use the carrying handle
9
.
Buch_75872_LB5.indb 57
Buch_75872_LB5.indb 57
22.06.12 14:32
22.06.12 14:32