Parkside PDSP 1000 A1 - Manual (Page 11)

11 GB
Q
Filling the blast medium container
Always use a suitable blast medium for your sand blasting work.
NOTE: We recommend using a silica-free blast medium
(e.g. ground blast furnace slag) with a grading of 0.2 mm–0.8 mm.
Ensure that the blast medium is completely dry and not too coarse.
NOTE: The maximum particle size is 0.8 mm.
Turn the bayonet cap of the blast medium container 4 to open it.
Pull the blast medium container 4 off downwards.
Fill the blast medium container 4 with the desired amount of
blast medium.
Ensure that the maximum capacity of the container (1000 ml) is
not exceeded.
Screw the blast medium container 4 back on and lock it in place
by inserting and turning it on to the container lid (see Figs. A).
Q
Using the sandblasting gun
(see Figs. B, C)
Carefully prepare the workpiece before sand blasting it.
Clean it if necessary.
NOTE: Deposits of dust and grease can have a considerably
detrimental effect on the result.
Carefully mask or tape off everything that is not to be sand blasted.
Ensure that there is always a minimum distance of 20 cm between
the sandblasting gun
1 and the surface being sand blasted.
Switching on:
Press the trigger 2 to start operating the sandblasting gun 1 .
Operation Safety advice / Operation