Using the sandblasting gun (see figs. b, c) – Parkside PDSP 1000 A1 User Manual
Page 10
10 GB
Operation / Cleaning / Service / Warranty
Operation
Ensure that the blast medium is completely dry and not too coarse.
NOTE: The maximum particle size is 0.8 mm.
Turn the bayonet cap of the blast medium container
4
to open it.
Pull the blast medium container
4
off downwards.
Fill the blast medium container
4
with the desired amount of
blast medium.
Ensure that the maximum capacity of the container (1000 ml) is
not exceeded.
Screw the blast medium container
4
back on and lock it in place
by inserting and turning it on to the container lid (see Figs. A).
Q
Using the sandblasting gun
(see Figs. B, C)
Carefully prepare the workpiece before sand blasting it.
Clean it if necessary.
NOTE: Deposits of dust and grease can have a considerably
detrimental effect on the result.
Carefully mask or tape off everything that is not to be sand blasted.
Ensure that there is always a minimum distance of 20 cm between
the sandblasting gun
1
and the surface being sand blasted.
Switching on:
Press the trigger
2
to start operating the sandblasting gun
1
.
Switching off:
Release the trigger
2
to stop operating the sandblasting gun
1
.
After you finish work, disconnect the device from the compressed
air source.
NOTE: First disconnect the hose from the compressed
air source and only then disconnect the compressed