Parkside PSZ 250 B2 - Manual (Page 9)

9 GB
ATTENTION! In the event of an emergency, imme-
diately activate the emergency stop switch
9 to stop
the cable hoist. The cable hoist cannot be operated
if the emergency stop switch has been activated.
Cleaning, maintenance and
ordering spare parts
Cleaning
ATTENTION! Unplug the mains plug from the
socket before cleaning.
Do not use cleaners or solvents; these could
affect the plastic parts of the device.
Ensure water cannot penetrate the housing.
Keep safety devices, venting slots and the motor
housing as dust and dirt free as possible.
Rub the device down with a clean cloth or
blow out with compressed air at a low pressure
setting.
Regularly clean the device with a damp cloth and
a little soft soap.
Note: We recommend cleaning the device
immediately after every use.
Maintenance
ATTENTION! Verify the device is not connected to
the mains when performing care.
Below: A cycle corresponds to moving a load up
and down once.
Periodic inspection corresponds to an inspection
after 100 cycles.
Periodically check the end switches on the cable
hoist are working properly (check without load).
Test as follows: When the cable reaches the
maximum hoisting height the auto-stop mecha-
nism lever
5 is activated. The motor 14 must
now stop. When the steel cable 6 is unwound
as far as possible, the maximum cable length
lever
4 is activated. The motor 14 must now
stop.
Periodically check the power cable 12 and the
control lead 13 .
Lubricate the steel cable 6 and pulley 15 every
200 cycles.
Every 30 cycles verify the entire steel cable 6
is in good working order in accordance with Fi-
gure I. If damaged, it must be replaced with a
steel cable corresponding with the technical data.
Every 1000 cycles check the screws on the
mounting bracket 1 and pulley 15 are tight.
Every 1000 cycles verify the hooks 8 / 16
and the pulley 15 are in good condition.
Verify the emergency stop switch 9 and push
buttons 10 are in good condition before every
use.
Check the brake system every 1000 cycles. If
the motor 14 emits unusual noises or is unable
to hoist the rated load, the brake system may
need to be overhauled:
- Replace damaged or worn parts and keep
the associated maintenance documentation.
- Please contact an authorised service centre
for unscheduled maintenance work.
Disposal
The device is packaged to protect it from transport
damage. This packaging is a raw material and there-
fore reusable or may be recycled. The device and
its accessories are made from various materials, e.g.
metal and plastics.
Dispose of defective components through toxic waste
disposal. Contact the speciality retailer or your mu-
nicipal government for information!
Do not dispose of power
tools in household waste!
In accordance with European Directive 2012 / 19 / EU
on waste electrical and electronic equipment and
its implementation into national legislation, worn
out power tools must be collected separately and
recycled in an environmentally friendly fashion.
Operation / Cleaning, maintenance and ordering spare parts / Disposal Safety notices specific to the device / Before using / Operation
100684_par_Seilhebelzug_content_PL_SI_SK_NL.indd 9 02.07.14 12:41