Parkside PAWS 3.6 A1 - Manual (Page 49)

49
MT GB
Push the slide of the interchangeable cord-
less screwdriver (
B
12) to the back.
Only grab the side of the
slide of the interchangeable
cordless screwdriver.
Caution, risk of injury caused
by pinching!
The selected bit is automatically fixed in
the bit holder ( 2).
3. Use extension bit holder
Remove the current bit ( 1) from the bit
holder ( 2).
Insert the extension bit holder ( 10) into the
bit holder ( 2). It may be that you need to
rotate the extension bit holder ( 10) slightly
because of the 6-point bit holder. Complete-
ly insert the extension bit holder ( 10) into
the bit holder ( 2). The extension bit holder
( 10) is held firmly by the duct and the
magnetic holder.
To remove the extension bit holder ( 10),
simply remove the extension bit holder from
the bit holder ( 2).
4. Switching on/off
Press the on/off switch ( 6) to start the de-
vice. To turn it off, release the on-off button.
If you move the direction switch ( 5) to
the middle position, the device is secured
against being switched on.
The LED lamp can continue to be used by
activating the switch block. To do so, press
the on/off switch.
5. Bit change in the
bit changeable drum
Select the bit that should be replaced (see
chapter „2. Bit selection from the bit chan-
geable drum“). To remove the bit, simply
remove the bit from the bit holder ( 2).
Insert a suitable 6-point bit in the bit holder
( 2). Because of the 6-point bit holder, it
may be that you need to rotate the bit slight-
ly. Slide the bit right into the bit holder (
2). The bit is held firmly by the duct and the
magnetic holder.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.