Parkside PAMFW 10.8 A1 - Manual (Page 30)

30 GB/MT
services providers. Contact with electricity
cables can lead to fire or electric shock.
Damaging a gas pipe can lead to an explo-
sion. Penetration of a water pipe can lead to
property damage or to electric shock.
If you use the device outdoors, always
connect it through a residual current
device (RCD) with a maximum trip
current of 30 mA. If using an extension lead,
always use one that is approved for outdoor use.
Any harmful / noxious dusts
generated from sanding represent a risk to the
health of the person operating the device and
to anyone near the work area.
Wear safety glasses and a dust pro-
tection mask!
Ensure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Safety notices for chargers
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
Advice on use
Principle of operation:
The oscillating motor allows the application tool to
oscillate back and forth 5000 to 19000 times per
minute. This allows for accurate working in the tight-
est of spaces.
Sawing / cutting:
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer’s recommendations.
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
Ensure that you use even contact pressure. This
will increase sanding sheet life.
Before use
Removing / charging / inserting
the battery pack
NOTE: The battery pack is delivered partly charged.
Charge the rechargeable battery in the charging
station for at least 1 hour before first use. This will
ensure the battery delivers full power. Li-Ion batteries
can be charged at any time without reducing the life.
Interrupting the charging process does not damage
the rechargeable battery.
1. To remove the battery pack
9 press the release
buttons 8 and slide the battery pack 9 out of
the unit.
2. Insert the rechargeable battery pack 9 into the
rapid charger 16 .
3. Insert the mains plug into the mains socket. The
status LED 17 will light up red.
4. The green charging status LED 18 indicates the
charging process has been completed and the
battery pack
9 is ready for use.
5. Slide the battery pack 9 into the unit.
Start-up
Checking the battery charge
When the device is on, the battery status indicator 2
indicates the status or the remaining power as follows:
RED / ORANGE / GREEN = maximum
charge / power
RED / ORANGE = medium charge / power
RED = low charge – recharge battery
Start-up General safety advice for electrical power tools / Before use / Start-up