Parkside PWS 230 A1 - Manual (Page 42)

38 PWS 230 A1
GB
Attaching the auxiliary handle
CAUTION!
► For safety reasons this device must always be
used with the auxiliary handle in place.
Otherwise you could become injured. Screw
the auxiliary handle on the left, right or on
the top of the head of the device.
Attaching and replacing roughing /
grinding / cutting discs
Always wear protective gloves when
changing cutting/rough grinding discs.
Roughing / grinding and cutting discs
become hot during use. Do not touch
them until after they have cooled down.
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fi t
on to the mounting fl ange without play. Do not use
a reducer piece or adapter.
■ Check the condition of the roughing / grind-
ing or cutting discs. They must be free of dam-
age, moisture or cracks. Otherwise they could
break up during use and cause injury.
NOTE
► Always ensure the discs are free of dirt
before use.
■ Use only abrasive consumables or tools with an
allowable speed at least as high as the no-load
speed of the device.
■ DANGER OF INJURY! Press the spindle lock
button only after the mounting spindle
has reached a standstill.
♦ Press the spindle lock button to block the drive.
♦ Release the clamping nut using the spanner
(see Fig. D).
♦ Place the roughing / grinding or cutting disc on
to the mounting fl ange with its labelled side
facing towards the device.
♦ Then replace the clamping nut , with its
raised side facing upwards, on to the mounting
spindle .
♦ Press the spindle lock button to block the drive.
♦ Tighten the clamping nut again with the
spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must immediately
be replaced.
♦ For safety’s sake, run at high idle for 60
seconds after every disc change. Be aware of
unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fi tted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Switching on and off
Check the accessory tool before use. It must be
properly installed, may not be damaged or damp,
should have no cracks and turn freely. Carry out
a 60 second test run. Do not use non-circular or
vibrating tools. Be aware of unusual noises and
sparks. Check whether all the fastening elements
are correctly installed.
Switching on:
♦ Press the safety lock-out (see Fig. E).
♦ Then press the ON / OFF switch .
Switching off :
♦ Release the ON / OFF switch .
Rotating the hand grip
■ The hand grip can be rotated by 90° to the
right or left (see Fig. A).
■ This allows the ON / OFF switch to be
brought into the most comfortable position for
any working conditions.
♦ Press the unlocking button and rotate the
hand grip to the right or left.
♦ Make sure the hand grip engages.
IB_103262_PWS230A1_LB2.indb 38 23.10.14 08:56