Parkside PLBS 30 B2 - Manual (Page 13)

13
d e
CAUTION - DANGER OF BURNS! Allow the
soldering iron to cool completely before cleaning. To avoid
damage, do not use aggressive cleaning material, metal brushes
or sharp objects such as knives, etc.
• Clean the device with a soft, slightly damp cloth if required. Ensure that no moisture enters
the device.
• Clean the soldering tips with the help of the cleaning sponge included in the pack
contents.
Cleaning
Troubleshooting
Fault Possible cause Troubleshooting
Soldering iron does not
heat up. No power supply. Check that the mains supply
(socket) functions correctly.
Ask a competent person for advice
if necessary.
Mains cable or plug
damaged. Have the mains cable replaced
by the manufacturer or the
manufacturer's representative.
The temperature of the
soldering tip is too low. Soldering tip is loose. Disconnect the soldering iron from
the mains. Allow the soldering iron
to cool down. Screw the soldering
tip firmly into the tip holder.
The solder does not run
smoothly on the soldering
iron. The soldering tip is not hot
enough. Wait until the soldering iron is hot
enough.
Allow the soldering iron to cool
down completely and check
whether the soldering tip is loose.