Enterasys Networks VSER-RPU-SYS - Manual (Page 20)

Installing the Redundant Power Supply
2-6
2
4. Power up the RPS by connecting one end of the AC cord to the AC receptacle
on the RPS, and the other end to a grounded power outlet.
5. Check the LEDs on the RPS to ensure proper operation. The Fan LED and the
RPS LED for connected switches should light up. If the LEDs indicate
otherwise, see "Troubleshooting" on page A-1 for more information.
Figure 2-5. Connecting Several Switches to an RPS
Note: For International use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the receptacle type in your country.
RPS output port
Stack
RPS input port
AC Power
Supply No.1
AC Power
Supply No.2
RPS Unit
100-240V, 50/60Hz 12.5A