Epson All-In-One Stylus Photo RX600 - Manual (Page 76)

76 Scanning to a Computer
Scanning Using the RX600 Buttons
You can use the buttons on the Stylus Photo RX600 to scan an image to your
computer, or to send an e-mail with a scanned image attached.
Note:
Both Epson Scan and Epson Smart Panel must be installed on your computer to scan to
your computer or to attach to an e-mail.
Scanning to Your Computer
1. Make sure the Stylus Photo RX600 is connected to your computer.
2. Open the scanner lid.
3. Place your photo face down on the glass in the upper left corner about
0.1 inch from the edges, as shown.
Note:
If you place your photo or document against the edge of the glass, the edges of
your photo or document may not be copied.
4. Close the scanner lid.
5. Press the Scan button to set the Stylus Photo RX600 to Scan mode.
6. Use the u and d buttons to choose Scan to PC , then press the OK button.
0.1 in
0.1 in
Move the document
in about 0.1 inch
from the edges
SP RX600 Users Guide.book Page 76 Thursday, January 29, 2004 1:08 PM