Curtis SPA021 - Manual (Page 7)

CARE AND MAINTENANCE
SPECIFICATIONS
TROUBLESHOOTING GUIDE
7
1. Clean the unit with a soft, damp (never wet) cloth. Solvent or detergent should never
be used.
2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places to
reduce the risk of fire or electric shock.
3. Keep your unit away from heating appliances and sources of electrical noise such
as fluorescent lamps or motors.
4. Unplug the AC adapter from the unit and the electrical power outlet immediately in
case of malfunction.
# If the sound is distorted: Try lowering the volume control of your sound source or
musical instrument. Also, try to reduce the overall volume of the unit.
# If there is too much bass: Try adjusting the bass control on the unit to lower the bass
level. This will allow you to play the music louder before clipping (distortion) occurs.
# If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphones away from the speaker.
#If you can’t hear the microphone over the music volume: Turn down the music volume
from your source.
Frequency:
FM 87.5 - 108 MHz
AC Adapter: Input - 120V~240V ~ 60Hz
Output - DC 15V 1A
Accessiories: AC Adaptor, Microphone x 1, RCA Audio Cable x 1
Rate Power: 10W (RMS: 15W)
Accessories: AC Adaptor, Microphone x 1, RCA Audio Cable x 1, instruction manual
Cabinet dimension: 265(L)*200(W)*370(H)mm
Weight: 11.3kg
PAIRING A BLUETOOTH DEVICE
1. Turn on your Bluetooth device.
2. Power on the unit and switch to Bluetooth Mode. It will automatically go into pairing
mode to search for Bluetooth devices. You will know you are in pairing mode when the
LED is blink.
3. If your Bluetooth device is not able to pair to the unit, switch off the unit and switch on
again to break previous Bluetooth connections and reset the Bluetooth module.
4. Navigate to your Bluetooth device’s setup screen, find “SPA021” and connect.
Note: If your Bluetooth device prompts for a pairing code, enter ‘0000’.
5. When LED will light up solid when it is 'paired'.
Note: Users should consider updating their OS if experiencing trouble with pairing
or playing music.
6. To disconnect pairing, switch off the unit.
7. To connect to another Bluetooth device, repeat steps 3-4.