Aquapur Handheld Steam Cleaner User Manual

Page 45

Advertising
background image

IT

en

43

EN

INSTRUcTIONS FOR USE

How to fill the boiler tank before use

ATTenTiOn: neVer unSCreW THe BOiLer TAnK CAp unLeSS YOu Are

Sure THAT THe AppLiAnCe HAS Been unpLuggeD frOm THe OuTLeT.

Unscrew the safety cap (C) and overturn the boiler tank to drain it completely.

Fill boiler with water (Fig. 1) by using the measuring cup (I) and the funnel (R).

The boiler must be filled completely using the measuring cup (I) twice filled with water up to

the black-coloured reference notch. Screw the safety cap (C) on again.

How to start the appliance
Insert the plug attached to the power cord into the outlet. The warning light (G) will go on.

Steam will be ready after about 3 to 4 minutes. Press button (D) to release steam.

AppLIcATION OF THE ATTAcHMENTS

Straight nozzle:

a) slide the accessory as far as the stop so that the nozzle reference slot and the yellow slot

on the appliance meet up (Figure 2);

b) turn in a clockwise direction until the mark on the nozzle is perfectly aligned with the two

lines on the appliance’s body. Now the attachment is blocked in the central position.

The appliance is provided with an articulated joint which allows the jet of steam to be

directed as desired: insert the straight nozzle until it covers the black round gasket. Bring the

nozzle reference line to meet the yellow slot on the appliance (Figure 2).

Turn in a clockwise direction until the mark on the nozzle is perfectly aligned with the two

lines on the appliance’s body. Now you can direct the jet of steam as desired (Figure 3).

round brush and bent nozzle:

Both these attachments can be applied to the straight nozzle (Figure 4 and 5) and the articu-

lated nozzle (Figure 6 and 7). Apply them to the hexagonal end and then choose the desired

angle.

flexible pipe, brush for fabrics and glass wiper:

The flexible pipe (O) must be attached to the articulated nozzle (B). Then apply the round

brush (L), the bent nozzle (M) the straight nozzle (N) and then the brush for fabrics (P) to the

hexagonal end on the pipe.

The brush for fabrics is provided with a cloth that can be used for the cleaning of delicate sur-

faces such as sofas and armchairs, and with a glass wiper to be fitted as shown in figure 8.

FILLINg THE BOILER TANK DURINg USE

When the water in the boiler tank has run out and you press the button (D) no steam will come out.

To refill, carry out the following operations:

• unplug the appliance;

• wait for about 10 seconds;

• carefully unscrew the safety cap (C). Before unscrewing it completely wait for the hissing

noise created by residual steam to stop;

• unscrew the cap completely and slowly pour a measuring cup of water into the boiler using

Advertising