Euro-Pro ULTRASHARK UV627 - Manual (Page 4)

Battery Removal & Disposal ASSEMBLING YOUR CORDLESS SWEEPER
Before you start:
Your Cordless Sweeper will require very little assembly. You should remove it from the
carton and familiarize yourself with all the components listed as per the exploded view
drawing (pg.2) This will help you in the assembly and operation of your cordless
sweeper.
Note: The charging adapter and the lower handle are shipped inside the dust cup.
Lower Handle
Fig. 1 Fig. 2
NOTE: If uncertain as to how to remove your battery pack, we suggest
you take your sweeper to a reputable small appliance service
technician to have this service performed.
Follow these steps when battery removal is required.
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them
properly. When the batteries are no longer good for use, they must be removed from
the sweeper for disposal. Do not remove the batteries for any reason other than
disposal of them. The batteries must be recycled or disposed of in accordance
with local regulations. Please consult your Yellow Pages or local recycling
center for more information.
WARNING: You must never use ordinary batteries for replacement as these
may leak and cause damage. Use only battery pack XBP615
for replacement.
Insert into Lower
Handle
Fig. 3
CAUTION: ALWAYS USE ADAPTOR SUPPLIED (ONLY)
WITH SWEEPER
1. In the event that the edging tool is not attached to the sweeper, insert the edging
tool into the "square" hole under the bottom of the sweeper power head. Gently
but firmly push until the edging tool locks into place. (Fig. 1)
2. Insert the lower handle - small end - into the sweeper power head. Push until
firmly in place. (Fig. 2)
3. Assemble the extension tubes by pushing the plastic insert into the mating extension
tube. (Fig. 3a) Push until only small portion of insert is visible or you cannot press
any farther into the tubing. Push the extension tube assembly into the upper handle.
(Fig. 3)
NOTE: One extension tube has a different plastic insert. This tube should be
on the bottom of the handle.
Insert the extension tube assembly into the lower handle so that the tab on the
plastic insert snaps into the open slot on the lower handle. (Fig. 3b)
4. Place the handle into the upward storage position.
5. Plug the charging adapter into the sweeper power head charging jack or plug the
charging adaptor into the charging jack of the charging stand. If using the charging
stand, place the sweeper onto the charging stand to charge. Plug the charging
adapter cord into a standard electrical outlet (120V, 60Hz.) The red charging
indicator should illuminate. If it does not, depress the On/Off switch one time.
Fig. 3a
Fig. 3b
Removal of Battery Pack
1. Remove the extension tube and dust container.
2. Turn unit over so that the base is facing upwards. Be careful NOT to turn the unit
ON. (Fig. 19)
3. Push in locking tab and lift off battery assembly. (Fig. 20)
4. Place battery assembly aside.
5. Insert the new battery assembly into unit. Ensure that locking tab snaps in place.
CAUTION: This appliance contains Ni-Cd batteries. The batteries must
be recycled or disposed of in accordance with local
regulations. Please consult your Yellow Pages or local
recycling center for more information.
Fig. 19 Fig. 20
8
3