Euro-Pro ULTRASHARK UV627 User Manual

Page 5

Advertising
background image

Changing the Rotating Brush, Gear Box & Squeegee

HOW TO OPERATE YOUR CORDLESS SWEEPER

WARNING:

Use caution when changing the rotating brush and gear

box so that the unit does not turn ON when pressing down

on the sweeper power head.

1. Before using, please ensure that the cordless sweeper has been initially

charged for 20 hours
Your cordless sweeper will only operate properly when the batteries are fully
charged. Your sweeper will operate for varying lengths of time on a full charge.
This will depend upon the type of surface being cleaned. (Longer operating time
on bare floors vs carpets.)

2. Push the On/Off switch to operate the unit. To turn off, press switch again.(Fig.4)

"On/Off" switch

Fig. 4

1. Remove the extension tube handle from the sweeper power head.

2. Turn sweeper power head upside down being careful Not to accidentally turn the

unit ON.

3. Remove the brush cover. (Fig. 13) (Refer to page 5 for detailed instructions.)

4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 14 &

Fig. 15)

5. Lift the brush bar end cap up from the slot. (Fig. 16)

6. Pull the brush bar out from the bushing and slip off the belt to remove the brush bar.

(Fig. 17)

7. Insert the new brush bar by first inserting the brush bar into the bushing on the end

opposite the driver belt. (Fig. 17)

8. Slip the belt over the brush bar cap.

9. Insert the brush bar into the slot. (Fig. 16)

10. Insert the gear box tabs into the tab slots and push down until it clicks into place.

11. To replace the squeegee, follow instructions above for removing the gear box and

slide the squeegee out from left to right. (Fig. 18)

CAUTION:

Any electronic or electrical appliance should not be
stored in or exposed to areas of high heat or humidity. Do

not store your cordless sweeper close to stoves,

radiators, furnaces or in a bathroom or bathing area.

Gear box

tabs

Locking

tab

Lift

Fig. 16

Fig. 17

Gear box

Fig. 13

Fig. 14

Fig. 15

Fig. 18

3. To release the handle to a comfortable position, apply pressure to the top of the

sweeper head with your foot while pulling back on the handle.(Fig. 5)

Fig. 5

4. To change the speed of the sweeper, press on

the speed control button. As you press on it, the
speed indicator light will change. If one light lights
up, you have the low speed for hard floors; two
lights, medium speed for carpeting; three lights,
high speed for turbo deep cleaning. (Fig. 6)

5. Flashing LED lights indicate that the brush bar

system id blocked or jammed. If this occurs, first
turn the unit off, then remove the obstruction
before turning the unit on again.

Hard floors

Carpeting

Turbo Deep

Cleaning

Fig. 6

4

7

Advertising