Sybase XTNDAccessTM - Manual (Page 7)

7
Infrared Setup for Windows Me
For Windows Me, no additional drivers or applications are required to use the
XTNDAccess IrDA PC Adapter. However, the following setup must be
performed in order for the Adapter to work with your computer.
1. Verify the serial connector of the Adapter is attached to a serial port of
the computer.
2. On the Microsoft Windows Me CD-ROM, locate the Tools\Pssutil
folder. From within this folder, double-click the Irdasir.reg file and then
click Yes to update the registry.
3. Reboot if prompted, then perform the following steps:
a. From the Start menu, select Settings, Control Panel, and then Add
New Hardware.
b. On the Add New Hardware Wizard, click Next.
c. Click Next again to allow Windows to search for Plug and Play
devices. A list may or may not appear.
d. Select No, The device isn’t in the list, and click Next.
e. Select No, I want to select the hardware from a list, and click
Next.
f. Select Infrared devices as the Hardware type and click Next.
g. Click Next to continue the installation of the infrared device.
h. Select Infrared COM port or dongle as the Manufacturer
i. Select Generic Infrared Serial Port or dongle as the Infrared
Device and click OK.