Casio E-200 - Manual (Page 21)

21
Using the CASSIOPEIA USB Cable
You can use the CASSIOPEIA USB cable to connect the CASSIOPEIA directly to a
computer.
Important
• See “Required System Configuration” on page 44 for the computer system that is
required for direct USB connection.
• The illustration below is just one possible connection configuration. The location and
layout of USB ports vary from computer to computer. See the documentation that
comes with your computer for full details on connecting cables to it.
• You must have ActiveSync installed on your computer in order to exchange data with
the CASSIOPEIA over a USB connection. See the ActiveSync Help for details about
setting up and using ActiveSync.
To connect to a computer using the CASSIOPEIA USB cable
Important
Before connecting your CASSIOPEIA to a computer, make sure you first install the
ActiveSync on your computer. Use the steps below to connect the CASSIOPEIA to
your computer when prompted to do so during the software installation procedure.
1. Plug the USB cable into the USB port of your computer.
2. Turn off your CASSIOPEIA.
3. Connect the other end of the USB cable to your CASSIOPEIA.
• To disconnect the USB cable, squeeze in on the buttons on either side of the plug to
unlock it, and then pull.
USB port
CASSIOPEIA USB cable