Eclipse - Fujitsu Ten BEC105 - Manual (Page 10)

Weatherstrip
• Confirm that the rear camera cable does
not get pulled and that the cable ties and
clamps do not come off when the back door
is opened and closed.
• Take care when routing the cable through
the trunk to ensure that rainwater cannot
get inside the vehicle.
Front of vehicle
Clamp Route the rear camera cable while securing it
with the cable rails, commercially-available cable
tie,and commercially-available clamp.
10
• The cable rails should be cut to appropriate
lengths.
Tip
Place the cable into the slit of the waterproof
cushion.
11
Attach the waterproof cushion to the weatherstrip. 12
Cable tie
Front of vehicle
Clamp
Front of
vehicle
Waterproof cushion 7
Cable rail
Front of vehicle
Camera cable
Camera cable
Luggage finish plate
3mm
3mm
Position with no
rib on underside
Route the rear camera cable while securing it with
the harness affixing tape.
13
Cut the luggage finish plate so that the camera
cable does not get caught on it.
14
• Check that there is no rib on the underside
of the luggage finish plate at the notch
position.
Tip
• Take care when routing the cable through
the trunk to ensure that rainwater cannot get
inside the vehicle.
Route the rear camera cable through to the main
unit .
15
Wrap the intermediate connector of the rear
camera cable with harness affixing tape to
dampen any noise.
16
Harness affixing tape 6
Harness affixing tape 6
5