Eclipse - Fujitsu Ten BEC105 - Manual (Page 11)

Camer Camer a Angle Adjustment a Angle Adjustment
• When adjusting the camera images, apply the vehicle's parking brake and be sure to chock the wheels of the
vehicle so that the vehicle will not move, otherwise accidents or injuries may occur.
After connecting the rear camera cable to the
main unit, connect the battery cable.
1
Move the selector lever to the R position to
display images from behind the vehicle.
2
Loosen the adjustment screw and adjust the
angle of the camera so that the rear of the vehicle
(rear window, back door, rear bumper, etc.) are
visible as shown in the diagram.
3
After adjusting the angle, securely tighten the
adjustment screw.
At this time, secure the bracket adjustment screw
so that it is at either end of the slot in the bracket.
4
• Prior to adjusting the rear camera angle,
check that gear was shifted into Park or
Neutral position.
• Be careful not to pull on the cable when
adjusting the angle of the rear camera.
• Check the adjustment screw regularly and
re-tighten if it becomes loose.
Tip
Rear camera 1
Screw (M3x6) 3
- Angle adjustment -
- Mounting adjustment -
Rear of vehicle
- Main unit -