Casio PL-40R 2 - Manual (Page 22)

Using the Sequencer
E-54
The following are the three basic types of data recorded by the
sequencer.
Š The time signture setting (stored in the song header).
Š Initial track parameters (stored in the song header).
Š Parameter changes and operations performed during
recording (stored at the point in the recording where you
make them).
You should also note that the data you can record in the
system track is different from the data you can record in
the 16 tracks.
Š For more detailed information about the data that can be
recorded in each track, see the “Parameter List” at the back
of this User’s Guide (page A-17).
The settings of the parameters listed below are stored as
header data and applied to all tracks. You cannot change
these settings part way through a song or for a particular
track.
Š Time signature (0, 2/4 to 7/4, 9/4, 12/4, 3/8, 5/8, 6/8, 7/8, 9/
8, 12/8)
Š Effect type
Š Tune setting (Master Tune, Baroque Pitch, Temperament)
J System Track Initial Parameters
When you start recording of the track, the settings of these
system tarck parameters are stored in the song header. You
can change these settings using the procedure under
“Changing Song Header Data” on page E-60.
Š Rhythm selection
Š Tone settings
Upper1, Upper2, Lower1, Lower2 tones, on/off status,
split point setting
Š Tempo
Š Transpose
Š Mixer settings
Settings are recorded for each auto accompaniment and
melody part and cannot be changed (except for mixer
volume) once recording starts.
Š Auto accompaniment mode
Š Auto harmonize on/off status
J Parameter Changes and Operations During
System Track Recording
Š Notes played on the keyboard (including chords in the
accompaniment keyboard range)
Š Pedal operations
Š Rhythm changes
Š Tone changes
Š Tempo changes
Š Auto accompaniment mode changes
Š Auto accompaniment controller operations (except for
START/STOP button): INTRO, FILL-IN, BREAK,
VARIATION 1/2, SYNCHRO START/STOP, ENDING.
Š Accompaniment keyboard range chords
Š Effect type changes
J Initial Track Parameters
When you start recording of the track, the settings of these
parameters are stored in the song header. You can change
these settings using the procedure under “Changing Song
Header Data” on page E-60.
Š Tone assignment
Š Mixer settings
J Parameter Setting Changes and Operations
During Track 1 to 16 Recording
Š Melody notes played on the keyboard
Š Pedal operations
Š Tone changes
Sequencer Record Data
Parameters Applied to All Tracks
System Track Data
Track 1 to 16 Data
426-E-056A
PL40NE01-1.book 54 ページ ２００２年７月２３日 火曜日 午後６時５２分