Exergen DX - Manual (Page 5)

DX 1601 0 to 1600°F (86 to 871°C) Unit includes a
Remote Sensor, 9 V DC Alkaline Battery and DX
Instruction Manual. Also available with an RS232
Digital Output and an Analog Output.
Chapter Two - Operation
2.1 DX Controls
2.2 To Change Display Measurement Units
The DX Models come from the factory displaying tempera-
ture in units of Fahrenheit. To display readings in units of
Celsius, perform the following steps:
1. Remove the screw from the underside of the case.
2. Remove the cover, exposing the battery area.
3. Locate the push button switch as shown in the picture.
4. With the unit off (display is blank), push the push but-
ton in.
5. Holding the push button in, turn the unit on with the
MEASUREMENT button.
LED Display
MEASUREMENT
button
LED Display
Sensor Window
AECS Cup
Battery Cover
Screw
Displays target temperature and diag-
nostic codes
Measurement
button To turn on and start temperature meas-
urement
Nosepiece
w/AECS cup
Sensor window
Automatic emissitivity compensation
system nosepiece to contact target
Sensor viewing area for IR detector
2