Powerplus POWX139 FILE / BELT SANDER 400W EN - Manual (Page 10)

POWX139 EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
9 CLEANING AND MAINTENANCE
Always ensure that the tool is switched off and the plug is removed from the power
socket before making any adjustments or maintenance procedures.
Keep the tool
’s air vents unclogged and clean at all times.
9.1 Replacing the carbon brush
 During use, the carbon brushes will
wear down. This will result in a
possible loss of power and excessive
sparking seen through the ventilation
slots. When the carbon brushes have
worn down to approximately 4-5 mm,
they will require replacing. Carbon
brushes must always be replaced in
pairs.

Tool service and maintain must be
performed only by qualified repair
personnel.
10 TECHNICAL DETAILS
Model nr. POWX139
Rated Voltage 230-240 V
Rated Frequency 50 Hz
Rated Power 400 W
Variable speed 300-1700 min-1
Working bar length 83 mm
Sanding belt size 13x457 mm
Cable length 3 m
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
80 dB(A)
Acoustic power level LwA 91 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 1,2 m/s² K = 1,5 m/s²