Powerplus POWX242 TILE CUTTER 1100W 240MM EN - Manual (Page 7)

POWX242
EN
Copyright © 2014 VARO p a g e | 7 www.varo.com
8 ADDITIONAL SAFETY INSTRUCTIONS FOR BATTERIES
 When replacing batteries, always replace the complete set. Do not mix old batteries with
new ones.
 Prevent removed batteries from short circuiting.
 Do not store batteries where the temperature may rise above 50 °C, e.g. in a car which
has been parked in the sun.
 Do not burn batteries.
 Never attempt to open batteries.
 In case of battery leakage, carefully remove the liquid using a cloth. Avoid skin or eye
contact. Do not swallow. In case of skin or eye contact, rinse abundantly for 10 minutes
with clean water and consult a physician.
9 ASSEMBLY
9.1 Installing the stand (Fig.2-4)
 Fasten the feet (13) to the base frame (12) with the screws (19).
 Turn the base frame upright (see Fig. 5).
 PIace the water reservoir (3) in the base frame (12).
 Place the cooling water pump (13) in the water reservoir (3).
 Fill with water until the pump (13) is full.
 Place the complete tile cutting machine in water reservoir (3) (see Fig. 2).
 Unscrew the star grip screw (11) (for securing during transportation!).
9.2 Installation of the pump. (fig 3)
Never let the pump run dry. Always make sure that the suction opening is
fully immersed.
10 OPERATION
 Remove the head lock knob before use.
 Adjust the required tool position, then tighten all the adjusting knobs, fence bolts and mitre
gauge bolts.
 Before switching the machine on, make sure that the water pump is immersed.
Turn on the main switch and allow your tool to reach the maximum speed before commencing
cutting.
 Place the workpiece against the fence or mitre fence.
 Keep the workpiece in place and slowly guide the cutting disc through the workpiece.
 Do not exert pressure on the cutting disc. Allow the machine enough time to cut the
workpiece.
 Cutting actions tends to slow the blade down. Pressure should therefore be occasionally
released to allow the blade to regain the full speed.
 Regularly check if the cutting disc is sufficiently cooled.
 Make sure that the cutting disc is cooled with water Add some cooling water if necessary.
 Lock the head after use.
If holding the workpiece by hand take extreme care and ensure hand is kept
away from the cutting blade.
10.1 Switching on and off (fig. 6)
 To switch the machine on, set the on/off switch (16 ) to ‘I’.
 To switch the machine off, set the on/off switch (16 ) to ‘0’.