Powerplus POWX242 TILE CUTTER 1100W 240MM EN - Manual (Page 9)

POWX242
EN
Copyright © 2014 VARO p a g e | 9 www.varo.com
10.6 Use of the laser.
10.6.1 Switching the laser on./off
To Switch the laser on, push the on/off switch
to “I”.
The laser beam projects a thin red line on
your tile cutter surface.
To switch off, push the on/off switch to “O”
10.6.2 Checking/Adjusting the laser beam.
Before using the laser as guide, check that
the laser beam is projected correctly. The
red beam should coincide with the inside
(side of the motor) of the diamond disc.
If this is not the case, adjust the laser.
Loosen the hex bolt, adjust & re-tighten. You
can also adjust the inclination of the beam,
by turn the laser beam head.
10.6.3 Cutting a tile.
Mark the tile where it should be cut.
Before you start cutting, let the marked line on the tile coincide with the projected laser line.
Push the cutting head forward, cutting the tile at the desired size.
10.6.4 Replacing the laser batteries.
Slide the lid of the battery compartment open,
remove the empty batteries, put new
batteries in (2x AAA batteries , notice the
correct polarity + & - ! ) reclose the lid.