Powerplus POWXQ5350 MITRE SAW +UPPER TABLE 1800W 305MM EN - Manual (Page 15)

POWXQ5350
EN
Copyright © 2014 VARO P a g e | 15 www.varo.com
11.2.2 Riving knife (35)
 The riving knife prevents that a workpiece is grasped by the rising teeth of the saw blade
and is thrown in the direction of the operator.
 Always make sure that the riving knife is installed while working with the saw.
11.2.3 Lower saw blade guard (Fig. 2)
 The lower saw blade guard is designed to provide protection against accidental contact
with the saw blade.
 The safety saw blade guard must always be installed, while the machine is in operation.
11.2.4 Push block (37)
 A push block serves as an extension of the hand and protects against accidental contact
with the saw blade.
 Always use a push block, when the interval between the saw blade and the mitre and
width guide is less than 120 mm.
 Use the push block at an angle of 20° to 30° in relation to the surface of the saw table.
 Replace the push block when damaged.
11.2.5 Installation
HAZARD!
Before starting with the installation of the machine:
o Switch the machine “OFF”
o Remove the plug from the socket
o Wait until at the machine has come to a complete standstill
 Leave the saw head in a raised position.
 Set the mitre saw in the 0° position and tighten up the locking screw.
 You must position the lower saw blade guard correctly.
 Lower the saw head and lock it in position.
 Lower the saw table by means of pushing on this table after releasing the table stops.
HAZARD!
 Before starting to work, check that the following items are in a proper condition.
o Riving knife
o Safety saw blade guard
o Saw blade guard
o Push block
 Wear protective clothing and apply the necessary protective measures:
o Dust exhauster
o Ear protection
o Safety goggles
 Stand in the correct position for operating the machine
o At the front of the saw
o In front of the saw
o At the left side of the sawing line
o If two persons are working at the same time, then the other person must stand at a
sufficient distance from the saw.
 Use following accessories, if required by the type of work you are doing: